转轮除湿机是降低空气的含湿,获取了单调空气常用的除湿设备。它是利用了涂覆在缓慢旋转的多孔道轮状或环状载体上的吸湿剂来吸附透过该转轮的湿空气中所含的水蒸气分子;吸湿后的吸湿剂可在高温下脱水再生,恢复吸湿才调。其时仍在运用已被国外厂家挑选的纸制氯化锂吸湿转轮,除湿功率低、能耗高、寿命短。 转轮除湿机的运用,是有一定环境需要的,通常来讲首要有以下这些: (1)除湿机与障碍物之间、应当坚持一定的间隔,并留有一定的空间。 (2)除湿机不能放在低于处理空气露点的环境中,防止其内部出现结露表象。 (3)除湿机的运用环境中、应当有超卓的通风,不能有尘土、油污等,更不能有腐蚀性或许危险性的气体或物品。 (4)除湿机应设排水设备,以便当冷凝水的排放。 除湿机的操作规程,对它来讲也是很首要的一个有些,其首要内容有: (1)除湿机安装好往后、应当查看其是不是处于水平状况。 (2)除湿机的电气联接、应当由专业人员进行,防止出现问题。 (3)除湿机所运用的电源电压,应当符合规定需要。 (4)除湿机的工作和接连,不能通过电源的插拔来结束,这样对设备的损害是很大的。 (5)除湿机的放置是不是水平,给水是不是疏通,以及电源的运用是不是正常。 (6)除湿机假定长期不用的话、那么应当拔下电源插头,防止发作电消耗。
英文版:Rotary desiccant is to reduce the humidity of the air, to obtain the monotonous air commonly used in the desiccant equipment. It is the use of the coating in the slowly rotating porous wheel or ring carrier on the hygroscopic agent for the adsorption of water vapor molecules contained in the air through the wet runner; hygroscopic agent can be regenerated after moisture absorption dehydration under high temperature, moisture absorption and recovery ability. It is still in the use of foreign manufacturers has been selected paper lithium chloride absorption dehumidification runner, low power, high energy consumption, short service life.
The use of rotary wheel, there is a certain environmental needs, usually the first to have the following:
(1) between the desiccant and obstacles, should adhere to a certain distance, and have a certain space.
(2) the dehumidifier can not be placed in the lower air dew point in the environment, to prevent the internal condensation phenomenon.
(3) the use of the environment in the environment, there should be excellent ventilation, can not be dust, oil, etc., but also can not be corrosive or dangerous gases or goods.
(4) the drainage equipment should be set up to facilitate the discharge of condensed water.
The operating procedures of the desiccant, it is also a very important part of some of its primary content:
(1) after the installation of the machine, it is necessary to check whether it is in a horizontal position.
(2) the electrical connection of the desiccant, shall be carried out by professional personnel to prevent problems.
(3) the use of the power supply voltage, should meet the requirements.
(4) the work of the desiccant and a series, can not be through the power of the plug to end, so the damage to the equipment is very large.
(5) the placement of the desiccant is not a level, the water is not clear, and the use of power is not normal.
(6) if the unit is not in use for a long time, it should unplug the power plug and prevent the power consumption. 想了解更多关于转轮除湿机,工业转轮除湿机,低露点除湿机的相关信息,请持续关注江苏安迪盛空气处理设备有限公司官网www.jsadsair.com |